1-800-274-6018

 

Cones

The primary geometry of a Cone is an angled side wall. Cones may range from shallow, like a cymbal, to very deep, like a megaphone.

Venturi and Shade
The aluminum Venturi on the left channels air flow in car wash vacuums. The Shade on the right is used on outdoor light fixtures.
 
  Venturi Shade
Diameter 22.00" 24.00"
Height 06.63" 07.10"
Material Aluminum Aluminum
Thickness 0.125" 0.100"
Finish Brushed Brushed
 
 

Ripple Shade
This aluminum part is a shade for outdoor lighting. CNC spinning creates the basic funnel shape followed by a press operation which forms the ripples. This unique shape adds interest to the Lamp.
 
Diameter 19.50"    
Height 02.50"    
Material Aluminum    
Thickness 0.063"    
Finish Brushed    
 

Bell
This aluminum part is used as a horn. The beaded edge ensures safe handling and increased strength. The light brush finish provides an attractive appearance.
 
Diameter 5.00"
Height 3.85"
Material Aluminum
Thickness 0.040"
Finish Brushed
 

Pointed Cone
Cones are a common shape for spinning. This aluminum cone is unusual due to its steep angle and pointed nose.
 
Diameter 10.00"
Height 10.00"
Material Aluminum
Finish Brushed
 


Copper Cone
This copper part is a lamp cover for low voltage outdoor lighting. The Cone has a unique shape which adds interest and beauty to the lamp.
 
Diameter 8.00"
Height 5.50"
Material Copper
Finish Brushed
 

Planter
This aluminum part is used as a planter for indoor foliage. The tappered side and brushed finish creates an attractive Planter.

 
Diameter 14.00"
Height 11.50"
Material Aluminum
Thickness 0.090"
Finish Brushed
 

Basket Back
This stainless steel part is the back of the drum for a large commercial washing machine. HMS utilizes a combination of spinning and drawing to create an attractive and cost effective Basket Back.

 
     
Diameter 42.00"  
Height 03.00"  
Material Stainless  
Thickness 0.075"  
Finish Mill  
 
 

Contact us to find out how HMS can help you!